![]() ![]() But it didn’t last: subsequent tests failed to produce anything different than with only automatic Perspective correction, and auto Horizon resumed its normal behavior of reverting to 0.00. I then only had to apply +5 to Up/Down, and the result looked better than in PL5. But the Horizon slider didn’t revert to 0.00 after engaging auto Perspective correction. Same result as in my previous post.īut this wasn’t the case on my first try with PL6! At first, PL6 produced a better result when auto Horizon correction was engaged first. Then, In PL6/VP4, I have to add a manual Up/Down adjustment of +17, while in PL5/VP3 I have to add a manual Up/Down adjustment of +13, and the resulting image in PL5 is still better. Plus, the Horizon adjustment slider reverts to 0.00. ![]() Both undercorrect it with my complex test image, but in slightly different amounts.Īfter several attempts, I found that if I leave Horizon set to auto and then turn on auto Perspective correction, I get the exact same results I did before using only automatic Perspective correction. With Perspective correction off, I see that the automatic Horizon adjustment in PL5 applies a little bit more correction than the same adjustment in PL6. So I started with Horizon adjustments instead of automatic Perspective correction. That behavior changed somewhere along the line. It believe it used to be that Perpsective auto-correction automatically turned on the Horizon adjustment in auto mode (keeping it set to 0.00), and then nothing would change if you turned Horizon on and off. First, I’ve noticed in the past that applying automatic Perspective correction for verticals often adjusts the horizon also without changing the setting of the Horizon adjustment slider in PhotoLab. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |